100% Canadian Made Steroids

Sale!

Testosterone Enanthate

300 mg/ml
10 ml

Fusion Testosterone Enanthate is a long acting injectable ester based off of the parent androgenic hormone testosterone.
PRODUCT USAGE:
Dosage (Male): 250-1200mg per week
Dosage (Female): 50-150mg per week
Dosage Frequency: Every 3-7 days
Dosage Type: Intramuscular injection
Active Half-Life: Approximately 7-10 days

$70.00

Product Information

What is Fusion Testosterone Enanthate:

Fusion Testosterone Enanthate is a long acting injectable ester based off of the parent androgenic hormone testosterone. Testosterone Enanthate has an androgenic to anabolic ratio of 100/100. It has moderate estrogenic activity and is low in progestational activity. The half-life is approximately 9.5 days and has a detection time of up to 3 months. Fusion Testosterone Enanthate is available in a 10ml/300mg vial.

What does Fusion Testosterone Enanthate do:

Benefits:
Testosterone enanthate users can expect enhanced protein synthesis and nitrogen retention. IGF-1 output is increased as well as red blood cell count and hemoglobin. Glucocorticoid hormones are also inhibited to a degree causing a lowering of cortisol. These functional characteristics of enanthate allow recovery ability to occur at an improved rate and recovery time to be decreased. Body composition is affected positively as well.

Side Effects:
Cycling with testosterone enanthate will cause suppression of the HPTA (hypothalamic pituitary gonadal axis) while on cycle and the time it takes for the half-life to clear the system. Aromatization is a possibility with any testosterone based steroid. The higher the dose the more potential for estrogen conversion through the process of aromatization. Mild to moderate water retention throughout the body may occur. There is potential for male pattern baldness for those predispositioned to it. Other potential sides are oily skin, increased facial/body hair growth and acne or gynecomastia for some. Females need to be aware of the possible virilization effects of testosterone. Some of which are voice alterations in tone, menstrual disruption and change in texture of skin. Testosterone enanthate is not at risk for hepatotoxicity with the liver but with prolonged use can have a detrimental effect on lowering HDL cholesterol.

Reasons to take Fusion Testosterone Enanthate:

The primary reasons users take Fusion testosterone enanthate are increased strength, increased lean mass and an improved recovery ability. Other characteristics such as power, speed and endurance are also improved. Users can also expect a ‘fuller’ feel and look to their muscles while enjoying a leaner disposition in composition.

How do you use Fusion Testosterone Enanthate:

Doses will be determined by the user goal. Common cycles last anywhere from 8-16 weeks in length. A beginning cycle of testosterone enanthate can be anywhere from 400-600mg/wk while other advanced, larger users have been known to push the boundaries with doses of 800-1000mg+ per week. While some users may believe in the bigger dose bigger gains idea, let it be known that with any substance used there is a point of diminishing return. Despite testosterone enanthate’s longer release time many users break up injections to multiple times per week in a balanced fashion. Someone using 600mg/week would benefit from 2 or 3 injections as this will allow the blood profile of testosterone to be at a higher concentration than if only injecting 1 time per week. The enanthate ester is used as a testosterone base in cycles for bodybuilders and various strength athletes or as a stand alone. It can be stacked with a variety of other anabolics depending on the goal of the user. Those going for size in a cycle may use equipoise as an addition along with an oral like dianabol or anadrol, while those wanting to take a leaner approach may combine primobolan or masteron. Male users need to perform a post-cycle therapy protocol in order to get their natural testosterone production operating at a functional level again or switch to TRT (testosterone replacement therapy). Overall testosterone enanthate is a popular steroid with much versatility.

Safe Injection Practices

Make Sure You’re Injecting In The Right Place

The easiest places to inject are your glutes, quads or delts.

Injecting into these bigger muscles is much easier, but you still want to be careful to avoid any blood vessels or nerves.

GLUTES – Usually glutes are the largest and safest place to inject. Divide them into four, you want to inject into the upper, outer quarter. This is so you don’t hit or damage the sciatic nerve, which runs down the center of your glutes.

QUADS – Your quads are the next safest muscle to inject into after your glutes. You need to inject into your top outer thigh, half way between your knee and the top of your hip.

DELTS – Injecting into your delts can be a little scarier because the muscle is smaller. The injection should be given 3-5cms from the top, in the middle of your delt.

Cleaning Your Injecting Site Correctly Helps To Prevent Infections

  • Always wash your hands thoroughly with soap and water before any injection.
  • Wash your injecting site with soap and water as well, or clean the area with a single wipe of an alcohol swab. Scrubbing at your skin with the alcohol swab can spread bacteria around.
  • Allow your skin about a minute to dry before injection.
  • If using a multi-dose vial, swab the top of the vial before and after you draw.

Injecting Into A Muscle Step By Step

  1. Draw up with an 18 gauge needle, then swap to a 25 gauge needle for injecting.
  2. Insert the needle at 90 degrees to your injection site. It should go in most of the way (1" to 1.5").
  3. Draw the plunger back slightly to check you haven’t nicked a vein or artery. If you have, you will see blood in the syringe. If this happens remove the needle and apply pressure with a clean tissue or swab.
  4. Keeping your injecting less than 2ml of fluid into each site – helps reduce your risk of infection.
  5. Inject slowly – 10 seconds per 1ml is a good pace.
  6. Remove the needle and apply pressure with a clean tissue or swab.
  7. Replace the needle cap and dispose of used syringe and needles in a proper bin.

Get Some Medical Advice If You Have:

  • any redness, pain, warmth, swelling or blistering at the injection site, or any feeling of chills or fever – you could have an infection or abscess
  • a feeling like an "electric shock" when injecting, or any type of ongoing numbness or tingling – these could be signs of nerve damage

DISCLAIMER: FUSIONSTEROIDS.COM DOES NOT PROVIDE MEDICAL ADVICE

The information, including but not limited to, text, graphics, images and other material contained on this website (fusionsteroids.com) are for informational purposes only. No material on this site is intended to be a substitute for professional medical advice, diagnosis or treatment. Always seek the advice of your physician or other qualified health care provider with any questions you may have regarding a medical condition or treatment and before undertaking a new health care regimen, and never disregard professional medical advice or delay in seeking it because of something you have read on this website. The legality regarding anabolic steroids, growth hormone, and other performance related drugs vary from country, state and province. If any drugs are illegal according to the laws governing in your country, state and province, please do not engage in their use.

Fusion Steroids 100% Canadian made

Fusion Steroids is your trusted source for 100% Canadian made anabolic compounds. Our top-quality products are made from the purest pharmaceutical grade raw ingredients, to help you not only achieve, but surpass your bodybuilding, fitness and performance milestones. When you choose Fusion Steroids, you are getting potent, fast acting compounds (steroids, HGH, SARMs, and Peptides), that are manufactured and meticulously tested to be the top performance enhancing products out there. Our discreet and secure shipping ensures your products arrive safely and on time. At Fusion Steroids we are dedicated to providing exceptional quality, that costs you less, and you can rely on to build muscle and crush your fitness goals. 100% Canadian made steroids.