100% Canadian Made Steroids

Testosterone Propionate

100 mg/ml
10 ml

Fusion Testosterone Propionate is a short acting injectable ester based off of the parent androgenic hormone testosterone.
Dosage (Male): 500-1500mg per week
Dosage (Female): 25-75mg per week
Dosage Frequency: Every 3 days
Dosage Type: Intramuscular injection
Active Half-Life: Approximately 2 days


Product Information

What is Fusion Testosterone Propionate?

Fusion Testosterone Propionate is a short acting injectable ester based off of the parent androgenic hormone testosterone. Propionate has an androgenic to anabolic ratio of 100/100. It has moderate estrogenic activity and is low in progestational activity. The half-life is approximately 2 days and has a detection time of up to 3 weeks. Fusion Testosterone Propionate is available in a 10ml/100mg vial.

What does Fusion Testosterone Propionate do:

Testosterone propionate users can expect enhanced protein synthesis and nitrogen retention. IGF-1 output is increased as well as red blood cell count and hemoglobin. Glucocorticoid hormones are also inhibited to a degree causing a lowering of cortisol. These functional characteristics of propionate allow recovery ability to occur at an improved rate and recovery time is decreased. Body composition is affected positively as well.

Side Effects:
Cycling with propionate will cause suppression of the HPTA (hypothalamic pituitary gonadal axis) while on cycle and the time it takes for the half-life to clear the system. Aromatization is a possibility with any testosterone based steroid. The higher the dose the more potential for converting to estrogen through the process of aromatization. Mild to moderate water retention throughout the body may occur. There is potential for male pattern baldness for those predispositioned to it. Other potential sides are oily skin, increased facial/body hair growth and acne or gynecomastia for some. Females need to be aware of the possible virilization effects of testosterone. Some of which are voice alterations in tone, menstrual disruption and change in texture of skin. Testosterone propionate is not at risk for hepatotoxicity with the liver but with prolonged use can have a detrimental effect on lowering HDL cholesterol.

Reasons to take Fusion Testosterone Propionate:

Increased strength, increased lean mass and an improved recovery ability are the primary reasons users take testosterone propionate. Other characteristics such as power, speed and endurance are also improved. Users can also expect a ‘fuller’ feel and look to their muscles while enjoying a leaner disposition in composition.

How do you use Fusion Testosterone Propionate:

Doses are dependent on the goal of the user and their pain threshold. As propionate is a short acting ester it is often injected every other day in doses of 50-200mg within a cycle of 6-12 weeks in length. While gains can be dose dependent to a degree it is to be noted with any substance there is a point of diminishing return and the happy medium with most for prop is 400-600mg/week in males depending on how aggressive one wants to be and their specific goals. Females who opt to use propionate use lower doses in the range of 25-50mg/week and some aggressive users may push doses to the 100mg/week mark. Women need to keep their cycles in the 4-8 week range due to the virilization characteristics of testosterone that can occur.

Because testosterone propionate is short acting it can be included in short or long cycles and pairs well with most any other AAS. It’s most widely used with strength athletes and bodybuilding competitors during contest preparation. Propionate is commonly seen stacked with trenbolone acetate or masteron propionate and injectable or oral winstrol leading up to a competition. Recreational users will also stack prop with anavar for a cutting based type cycle. While some believe there will be less water retention from using prop versus longer esters of testosterone enanthate or testosterone cypionate it needs to be noted from a practical standpoint this is not always the case and oftentimes better conditioning needs to be attained.

Consistent or chronic usage of anabolic steroids will cause a thickening of the blood known as polycythaemia. It is recommended to give blood periodically in order to combat this. Due to the potential of anabolics lowering HDL it is also recommended to be consuming high quality sources of EPA and DHA (Omega 3) nutritionally to assist in keeping a healthy HDL/LDL ratio. Lastly, for males cycling it is imperative users perform a post cycle therapy protocol in order to get their natural testosterone production operating at a functional level or switch to TRT (testosterone replacement therapy).

Safe Injection Practices

Make Sure You’re Injecting In The Right Place

The easiest places to inject are your glutes, quads or delts.

Injecting into these bigger muscles is much easier, but you still want to be careful to avoid any blood vessels or nerves.

GLUTES – Usually glutes are the largest and safest place to inject. Divide them into four, you want to inject into the upper, outer quarter. This is so you don’t hit or damage the sciatic nerve, which runs down the center of your glutes.

QUADS – Your quads are the next safest muscle to inject into after your glutes. You need to inject into your top outer thigh, half way between your knee and the top of your hip.

DELTS – Injecting into your delts can be a little scarier because the muscle is smaller. The injection should be given 3-5cms from the top, in the middle of your delt.

Cleaning Your Injecting Site Correctly Helps To Prevent Infections

  • Always wash your hands thoroughly with soap and water before any injection.
  • Wash your injecting site with soap and water as well, or clean the area with a single wipe of an alcohol swab. Scrubbing at your skin with the alcohol swab can spread bacteria around.
  • Allow your skin about a minute to dry before injection.
  • If using a multi-dose vial, swab the top of the vial before and after you draw.

Injecting Into A Muscle Step By Step

  1. Draw up with an 18 gauge needle, then swap to a 25 gauge needle for injecting.
  2. Insert the needle at 90 degrees to your injection site. It should go in most of the way (1" to 1.5").
  3. Draw the plunger back slightly to check you haven’t nicked a vein or artery. If you have, you will see blood in the syringe. If this happens remove the needle and apply pressure with a clean tissue or swab.
  4. Keeping your injecting less than 2ml of fluid into each site – helps reduce your risk of infection.
  5. Inject slowly – 10 seconds per 1ml is a good pace.
  6. Remove the needle and apply pressure with a clean tissue or swab.
  7. Replace the needle cap and dispose of used syringe and needles in a proper bin.

Get Some Medical Advice If You Have:

  • any redness, pain, warmth, swelling or blistering at the injection site, or any feeling of chills or fever – you could have an infection or abscess
  • a feeling like an "electric shock" when injecting, or any type of ongoing numbness or tingling – these could be signs of nerve damage


The information, including but not limited to, text, graphics, images and other material contained on this website (fusionsteroids.com) are for informational purposes only. No material on this site is intended to be a substitute for professional medical advice, diagnosis or treatment. Always seek the advice of your physician or other qualified health care provider with any questions you may have regarding a medical condition or treatment and before undertaking a new health care regimen, and never disregard professional medical advice or delay in seeking it because of something you have read on this website. The legality regarding anabolic steroids, growth hormone, and other performance related drugs vary from country, state and province. If any drugs are illegal according to the laws governing in your country, state and province, please do not engage in their use.

Fusion Steroids 100% Canadian made

Fusion Steroids is your trusted source for 100% Canadian made anabolic compounds. Our top-quality products are made from the purest pharmaceutical grade raw ingredients, to help you not only achieve, but surpass your bodybuilding, fitness and performance milestones. When you choose Fusion Steroids, you are getting potent, fast acting compounds (steroids, HGH, SARMs, and Peptides), that are manufactured and meticulously tested to be the top performance enhancing products out there. Our discreet and secure shipping ensures your products arrive safely and on time. At Fusion Steroids we are dedicated to providing exceptional quality, that costs you less, and you can rely on to build muscle and crush your fitness goals. 100% Canadian made steroids.